Now I am design one double balanced mixer,
using Schottky Barrier Diode Quads.
The final layout (draft) is attached.
Can anyone give me some advice on the following issues:
(1) Ribbon wire, Can I use Ribbon wire to cross another transmission
line vertically, or some angle (< 90) needed?
(2) Because, I have two balun, one for LO, another for RF,
which balun should I put the diode near to? RF one or LO one?
hi, i want to design the balun for wideband,but i dont how to design the balun
i refrence the book mass writted but i simulate the balun ,the result is not good,
can you tell me u how to design the balun