mjl23
Newbie level 4
HI
I am trying to design a low pass maximally flat RF filter the design requirments are set so that the filter is to be designed to be matched to a 50 ohm line i have calculated all of the components and matched the components to the line, in the design specification it is asking me to obtain a value for the reflection coeficient of less than 0.3, however with my components i am obtaining a reflection of around 0.7, was wondering if there are any adjustments i could make to the circuit in order to change the reflection coefficient? i am susre that providing it is lower than 1 and above -1 the filter is still stable, not sure what i need to do realy?
Thankyou for your reply's
I am trying to design a low pass maximally flat RF filter the design requirments are set so that the filter is to be designed to be matched to a 50 ohm line i have calculated all of the components and matched the components to the line, in the design specification it is asking me to obtain a value for the reflection coeficient of less than 0.3, however with my components i am obtaining a reflection of around 0.7, was wondering if there are any adjustments i could make to the circuit in order to change the reflection coefficient? i am susre that providing it is lower than 1 and above -1 the filter is still stable, not sure what i need to do realy?
Thankyou for your reply's