Delay values specified for cells in the library

Status
Not open for further replies.

venugopala_0202

Junior Member level 1
Joined
Apr 23, 2012
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,422
I have a very basic question related to STA. If I take a library pertaining to an operating condition(fast or slow or typical) will I get two sets of delay values (max and min) for each cell in the library? This question arose when I was reading the definition for single operating condition analysis in solvnet. It says that we use the same operating condition(library) for setup and hold check, but for setup check we take max values for launch clock and data path and min values for capture clock and the other way round for hodl check. So how is this possible for the same library without having two sets(max and min) of values for each cell for each operating condition?
 

Metalhead,

Aftrer doing the simulation on SS,FF,TT process the extreme values are loaded to library.

Set-up time depends on the operation frequency, where as Hold time does not depend.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…