Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

De-embedding measured S2P using ADS

Status
Not open for further replies.
M

mohandes79

Junior Member level 3
Junior Member level 3
Joined
Nov 3, 2006
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,445
Hi All,

I have got a measured s2p file and I need to de-embed it. I have also measured Open, Short, and Thru.

What would be the straightforward method using ADS to de-embed the raw data?

Thanks!
 

I think that is only measuring using test fixture. De-embed it become after additional test fixtures Open, Short, and Thru.
 

Something like these.
 

Attachments

  • Snap117.jpg
    Snap117.jpg
    119.6 KB · Views: 182

Thanks for your info. Let me explain more, I have taped-out a passive component and I would like to de-embed the PADS effect. I have also taped-out an OPEN, SHORT, and THRU of the DUT structure. How can I perform de-embedding?
 

On the pic. is thru and you should add short, loaded with small noniductive resistors and proper length and so on .
It has successfully Dan such staff for 2.5GHz. One company doesn't provide S par for one PA chip. Only ref design, witch was not so accurate with unknown substrate and crazy thickness.
And you should have bias network as well.
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top