Cabecinhas
Newbie level 3
Data from ADISUSBZ
Hi,
I'm a student of Electrical Engineering, Faculdade de Ciências e
Tecnologia of Universidade Nova de Lisboa in Portugal, and at the end
of my graduation I need to finalise my thesis with a research project.
The project consist in the stabilization of line-of-sight with two
angulare axes. We acquired the iSensor (ADISUSBZ) due to their
physical qualities, size and weight, as it will be attached to the
platform so we can read the information from the gyroscope. The
information obtained will be treated externally using LabVIEW for
create the control actions that will operate the servo and we'll get
the desired stabilization.
However, the difficulty it's reading data in Labview, because this
does not recognize the iSensor, hence the various attempts to create a
driver. Therefore, I asked what was the programming language to advise
the implementation of the controller to be able to do read the
iSensor.
I tried that:
https://zone.ni.com/devzone/cda/tut/p/id/4478
https://forums.ni.com/ni/board/message?board.id=170&message.id=340676&query.id=154370#M340676
but never can access the registry with information.
Thanks!
Best Regards.
Hi,
I'm a student of Electrical Engineering, Faculdade de Ciências e
Tecnologia of Universidade Nova de Lisboa in Portugal, and at the end
of my graduation I need to finalise my thesis with a research project.
The project consist in the stabilization of line-of-sight with two
angulare axes. We acquired the iSensor (ADISUSBZ) due to their
physical qualities, size and weight, as it will be attached to the
platform so we can read the information from the gyroscope. The
information obtained will be treated externally using LabVIEW for
create the control actions that will operate the servo and we'll get
the desired stabilization.
However, the difficulty it's reading data in Labview, because this
does not recognize the iSensor, hence the various attempts to create a
driver. Therefore, I asked what was the programming language to advise
the implementation of the controller to be able to do read the
iSensor.
I tried that:
https://zone.ni.com/devzone/cda/tut/p/id/4478
https://forums.ni.com/ni/board/message?board.id=170&message.id=340676&query.id=154370#M340676
but never can access the registry with information.
Thanks!
Best Regards.