Electronics_chaitanya
Member level 5
Hello Everybody
Currently i am trying to interface CT with Arduino.Rating of CT are as below
Is: 5A at Ip:50A
so it should produce 5A in secondary while 50A flowing through primary.
i am flowing 500mA in primary so it should produce about 0.05A,and i am connecting burden resistor of 50ohms so Vout should be
Vo=0.05*50=2.5V
but when i check with my voltmeter i am not getting these voltages.
I am not connecting any rectifier now i m measuring just with AC volt meter.
any advice suggestions are most welcomed
-Regards
Currently i am trying to interface CT with Arduino.Rating of CT are as below
Is: 5A at Ip:50A
so it should produce 5A in secondary while 50A flowing through primary.
i am flowing 500mA in primary so it should produce about 0.05A,and i am connecting burden resistor of 50ohms so Vout should be
Vo=0.05*50=2.5V
but when i check with my voltmeter i am not getting these voltages.
I am not connecting any rectifier now i m measuring just with AC volt meter.
any advice suggestions are most welcomed
-Regards