Create SAW filter topology in ADS

Status
Not open for further replies.
T

testdriver87

Newbie level 2
Joined
Nov 22, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
Create SAW filter layout in ADS

Hello!

I need to create any simple layout of SAW filter in ADS and simulate it...test example.
I have not found useful information about it in the internet. ADS is not good for this case?
Can you help me may be with example, may be with first steps.
I have worked with Ka-band, so I am novice in SAW. But certainly I know theory.

Thank you!))
 
Last edited:

Hi,
SAW filter is for : Surface Accoustics Waves. I think that you can't create a layout of this type of filter in ADS except a simulation of the schematic that modelize this filter.
SAW filters have a special substrate where accoustic wave travel. The transducers assume the conversion between electric HF signal and accoustic vibration signal.
In ADS you can not simulate accoustic signal and cannot realize a layout for accoustic wave.
I you succeed in realize this filter on ADS , i am also interested ...
 
At first, thank you for reply)
Of course I can simulate schematic, but I need to show layout simulation. I have asked this question on forum, because I dont know how realize this substrate or is it possible realize it. If it is not possible I have to explain it. Can I do it with the other software?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…