I use 2 metallic strips as ground planes and one strip between them as RF line. I set two opposite ports as "internal" and the other two couples of ports as "ground reference", obviously referred to the rispective internal port.
I noticed that S-parameters results from a full wave simulation of a simple 50 ohm CPW (for istance, 1 mm of length) are different from the CPW lumped element provided by the schematic tool of ADS.
Hi sool83,
I think that I can help you on CPW, I have already faced the same problem, actually it is a little bit difficult to do it in ADS, so send give me your email in order to send you some files. It is a little bit big and I can not upload it here.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?