Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

converting unipolar stepper to bibolar

Status
Not open for further replies.
R

raman00084

Full Member level 6
Full Member level 6
Joined
Nov 29, 2010
Messages
375
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
4,076
i am using l297 and l298 based stepper drive. i got 6 wire unipolar stepper motor, my doubt is that can i convert the unipolar to bipolar by ignoring the two center taped conman pins. does the motor run without any problem?
 

Yes, but keep in mind that the characteristics change since you've basically got two inductances in series when you run in bipolar.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top