Hi,
I have completed 4 channel Audio controller circuits,
brain of this kit is 89C52 based controller board, which is programmed for LCD interface, front panel with button and LED's
it supports PSU interface, Standby and Active mode.
after power on it goes to "Standby" mode, on press on button it goes into "Active" mode & prompts for channel selection, upon press of button it changes channel, same is displayed in LCD.
Active and Standby mode signals PSU, high and low .
Front panel button and LED:
Two buttons for Power on an other for Channel Select.
Two LED , Power on off LED and Button press response LED with option for buzzer (5 volts beeper) on board.
Image Description:
Image 1 (SEL_Standby2.jpg) : After Power ON, Standby mode.
Image2 (SEL_Select2.jpg_ : After press on button, Active , Select (prompt for channel Select)
Image 3 (SEL_Channel1.jpg) : After pressing Channel Select Button. Shows "Channel
Regards
Sudheer