acbalbason
Full Member level 2
- Joined
- Apr 8, 2007
- Messages
- 136
- Helped
- 11
- Reputation
- 22
- Reaction score
- 1
- Trophy points
- 1,298
- Location
- Gainesville, Florida
- Activity points
- 2,044
Hi All,
I have done conservative transient simulation in Cadence after doing ADC. I am trying to post process the output in Matlab using FFT. I have a 10ns period (sampling) but in between periods I have almost 400 points of data in between. This makes it hard to calculate the downsampling frequency since the number can change depending on the output. Is there a known way I can do this accurately? Not just by changing the downsampling frequency each time.
Thank you!
Alfonso
I have done conservative transient simulation in Cadence after doing ADC. I am trying to post process the output in Matlab using FFT. I have a 10ns period (sampling) but in between periods I have almost 400 points of data in between. This makes it hard to calculate the downsampling frequency since the number can change depending on the output. Is there a known way I can do this accurately? Not just by changing the downsampling frequency each time.
Thank you!
Alfonso