Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Connecting AD737(RMS to DC) to current transformer

Status
Not open for further replies.
S

stoyanoff

Full Member level 4
Full Member level 4
Joined
Aug 10, 2011
Messages
195
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Visit site
Activity points
2,725
Hi! I`ll work with AD737(https://www.farnell.com/datasheets/1610921.pdf) for very first time. I want to use it for current measurement through current transformer. I have current transformer with impedance of 50 omhs and transformation ratio 50A to 0.05A on the secondary coil. Can you give me an advice how to connect them?
Thanks!
 

well, I will use this AD736 for the 1st time like you! but I need to measure grid voltage.

in the datasheet, there's some circuits. But, I see that the recommended input is 1v rms (you can consider it 1v peak) and the max is 5v (sometimes = supply voltage).

so, what is the voltage I need to feed into the IC?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top