Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How can I configure a bluetooth module like Bluelink to work with hyperterminal ?, i attached the settings doc for it, anyone having experience with this module ?
Its user manual says, no need for any configuration to communicate with hyperterminal,
I can pair it with PC using dongle,
But cant send the data ......
Its user manual says, no need for any configuration to communicate with hyperterminal,
I can pair it with PC using dongle,
But cant send the data ......
Im looking for help, im using a btm180 to interface with a microcontroller. i want to use the at commands in Hterm but when i do i am getting no ok response, any ideas as to why this is?
if you want to interface as an UART, then program your uC and just connect it,
first do loop back test to find, if its working of not
care about rx and tx
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
