Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Computers doesn`t see each other in localnet...

Status
Not open for further replies.

kalach2002

Junior Member level 3
Junior Member level 3
Joined
Jun 29, 2002
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Russia
Activity points
260
PLS help!!!

1. When I had 2 comps - there were no any problem, just one twisted pair.
2. No I`ve got 4 comps & had to buy hub/switch, so when I connected RJ-45 with twistedPair and pluged it to Ethernet-card And to swith, the computers doesn`t see each other & doesn`t ping at all.

What`s the problem could be?

Maybe I connected RJ-45 with tw.p. incorrectly?
 

take care on the cables: for a direct connection it must be a cross-over-cable. But for a connection via hub it must be a 1:1-cable (not crossed). So you can't use the old cable anymore (except if connected to the uplink port - but that's too much for today ...)


Mik
 

So I shouln`t cross pairs connected two 1&2 and 3&6 pins, yes?
Is there difference on choosing pairs of different color?
 

kalach2002 said:
So I shouln`t cross pairs connected two 1&2 and 3&6 pins, yes?
Is there difference on choosing pairs of different color?

One of standart:
**broken link removed**
and
**broken link removed**
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top