Communicating to a device via Bluetooth in Labview

[Girly_girl]

Hi all,

has any one tried Communicating to a device via Bluetooth in Labview?
If so what are the approach? any .vi that I could start with?

Thank you

 

[ud23]

You can just build simple Serial communication vi for communication with your device ..Its given in the examples also. I used some time ago.

You need to check your device bluetooth baurd rate and set same in LABVIEW Serial communication module...

https://www.ni.com/example/27669/en/

download the attachment vi on the right hand side at given on above link

 

[Girly_girl]

Hi Thank you so much for your reply - do you have any idea on how I could check the baude rate of the bluetooth device? Its a Unique cfm device for collecting EEG signals

 

[ud23]

you can look in your Bluetooth hardware manual basically Bluetooth works on two modes command mode and data mode you can enter in command mode and see the configuration of your Bluetooth. I don't know about your Bluetooth mac but I can give you link for my Bluetooth user manual.

https://www.sparkfun.com/datasheets/Wireless/Bluetooth/rn-bluetooth-um.pdf

But Please do refer your device user manual ...