Electron3
Junior Member level 2
Hello all
i want help facing problem now;
i would like to design a power combiner at 250W CW at freq of 64 Mhz
i tried some gysel design approach with micro strips mender line on Er 3.5 with thickness of 1.5
s parameter characterization of designed prototype are successful
but some of my friend doubt about the same that whether it will handle such high power
i want help regarding power handling of same
if it not able to handle power which design approach i should consider
for gysel prototype i am considering heat sink calculation also
i want help facing problem now;
i would like to design a power combiner at 250W CW at freq of 64 Mhz
i tried some gysel design approach with micro strips mender line on Er 3.5 with thickness of 1.5
s parameter characterization of designed prototype are successful
but some of my friend doubt about the same that whether it will handle such high power
i want help regarding power handling of same
if it not able to handle power which design approach i should consider
for gysel prototype i am considering heat sink calculation also