[SOLVED] COE file creation problem for BRAM generator

Thread starter hodahussein
Start date Oct 5, 2010

Status: Not open for further replies.

Oct 5, 2010

hodahussein

Full Member level 2

dear all

i have a problem during generate BRAM (initialization it with coe file )
i created coe file with following syntax:

--------------------------
MEMORY_INITIALIZATION_RADIX=16;
memory_initialization_vector=
04,
04,
05,
04,
04,
04,
04,
04;
--------------------------
and save it in file with extention [ .coe],ok
and when initialize the BRAM, and load it with this file in [load init file ] step
already, i load it but, when i click on show button to check if this file valid or not
then i observe that in [coe file content]:

Radix : not found
also this message [ cannot find radix with name :MEMORY_INITIALIZATION_RADIX]

i need to explanation plz
regards

Attachments

Last edited: Oct 5, 2010

Status: Not open for further replies.

Similar threads

G
SDC file for clock creation
- Started by gahelton
- May 8, 2023
- Replies: 3
PLD, SPLD, GAL, CPLD, FPGA Design
Y
BRAM CONTROL ISSUE
- Started by YoungEN
- Nov 4, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design
K
What's the difference between RAM and ROM with a coe files in Xilinx FPGA?
- Started by kevinwang65
- Mar 11, 2024
- Replies: 13
PLD, SPLD, GAL, CPLD, FPGA Design
A
[SOLVED] Access BRAM from PS
- Started by aminpix
- Feb 23, 2023
- Replies: 2
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to instantiate another vhd file inside testbench, where the testbench is used for opening files
- Started by metamisers
- Jan 6, 2024
- Replies: 6
PLD, SPLD, GAL, CPLD, FPGA Design