Coaxial to microstripe transition

Status
Not open for further replies.
C

camel_RF

Junior Member level 3
Joined
Apr 9, 2004
Messages
25
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Activity points
275
Hi,

Can anyone tell me how I can optimize the transition between the coax to microstrip surface?
Any rule of thumb like solder, epoxy amount, shape of connector etc?

I am refering to high frequency usage that use connector like 1mm or 2.4mm.
Thanks in advance
 

use sma connector with appropriate impedance
 


Probably what I am asking is any considerating before go for simulation? Any trick or limitation that I shlould look at and others practical experience to share on this design?

Do I need to consider the width of the microstrip line under right below the connector pin?

And etc...
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…