Thomasdj
Member level 5
what should be the spec router stepper
Hello,
I am new to steppers so need a little help designing a stepper driver/controller to my CNC router project. I need to drive/control 4 motors with the following specs:
2 x Astrosyn L189/4 Phase:
Phase Current 1.6A
Phase Res 2.65ohm
Phase Ind 4.75mH
2 x Simostep P50/3 Phase, - see picture
The two simostep should run synchromesh.
Thanks
Thomas
Hello,
I am new to steppers so need a little help designing a stepper driver/controller to my CNC router project. I need to drive/control 4 motors with the following specs:
2 x Astrosyn L189/4 Phase:
Phase Current 1.6A
Phase Res 2.65ohm
Phase Ind 4.75mH
2 x Simostep P50/3 Phase, - see picture
The two simostep should run synchromesh.
Thanks
Thomas