Circuit to power on and off load from positive and negative

Status
Not open for further replies.

TekUT

Full Member level 6
Joined
Jun 17, 2008
Messages
323
Helped
39
Reputation
78
Reaction score
15
Trophy points
1,298
Location
Italy
Activity points
3,557
I've used this circuit to power on and off a sensor in order to make some measurement only when I need (was for a portable battery powered system). Sensor was powerd from +12SENS and -12SENS but you can set load also from power line and the reference voltage, all drived by a single pin of a micro (signal ENVPWR).

Hope this can be useful.

Cheers
F.F. a.k.a. Powermos
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…