Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

circuit to mesure ac voltage

Status
Not open for further replies.

hichamcentre

Junior Member level 1
Junior Member level 1
Joined
Sep 28, 2018
Messages
16
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
111
Hello everyone,


I am doing this circuit. c1.PNG


Here is the result I got,c2.PNG


However, in reality I could not get this signal.i don't know why
PS: I got the AC voltage by circuit a voltage divider.
 

Superposition theorem
The superposition theorem for electrical circuits states that for a linear system the response in any branch of a bilateral linear circuit having more than one independent source equals the algebraic sum of the responses caused by each independent source acting alone, where all the other independent sources are replaced by their internal impedances.
 

ac =1.5 V

dc =1.5 V
here is the schema in complis that I wanted to achieve
c4.PNG

however at the beginning I wanted to buy the op amp.

i tested the circuit with out amp op i jsute tested the input but i don't find what i need find
 

Hi,

Please focus on the "non working curcuit".
It makes no sense to show the "working" circuit, but complaining another circuit.
--> photo, exact schematic, exact components and wiring

And please give unambigous informations.
ac =1.5 V
In technical discussions we mainly use the RMS value.
In opposite to this in mathematical discussion one often uses the "amplitude value"

With sine value:
1V RMS = 1.414Vp (peak) = 1.414V ampltude = 2.828Vpp (peak-to-peak)
= 1.414V × sin(wt)

Btw: the simplest solution I see is just a capacitor and a resistor:
AC --- C --- (output) --- R --- 1.5VDC.

But there are several ways, with and without Opamp, with and without capacitor...
You first have to decide your requirements / specifications.

Generally: if the real results differ a lot from the expected results, then - most probably - you are doing something wrong.

Klaus
 

Coupling capacitor or transformer required for mixing AC signal + DC

for exampleAC DC mixing.jpg
 

thanks for the informations so if i understood you i must use a capacitor with the ac input
 
  • Like
Reactions: Binhnt

    Binhnt

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top