zahra110
Newbie level 1
Hi all,
I'm using ADXL375 accelerometer sensor connected to STM32F103 microcontroller.
I wanna enable the interrupt pin of sensor and connect it to one of input pins of microcontroller
in sensor datasheet it is said that interrupt pin is push pull active high.
now, the Question is that How should I configure the input pin of microcontroller that is connected to interrupt pin of sensor?
do I should set this pin as Input/ pull down pin, OR Input/Pull up pin OR Input/floating ?
Regards,
I'm using ADXL375 accelerometer sensor connected to STM32F103 microcontroller.
I wanna enable the interrupt pin of sensor and connect it to one of input pins of microcontroller
in sensor datasheet it is said that interrupt pin is push pull active high.
now, the Question is that How should I configure the input pin of microcontroller that is connected to interrupt pin of sensor?
do I should set this pin as Input/ pull down pin, OR Input/Pull up pin OR Input/floating ?
Regards,