Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

chipscope problem MIG virtex5

Status
Not open for further replies.
H

hastidot

Junior Member level 3
Junior Member level 3
Joined
Feb 27, 2011
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,611
Hi all

I'm using MIG as DDR2 controller in virtex5.
I created a cdc file for using chipscope. But while using the pins to trigger, only one bit of some registers appears in the list, but I need to trigger all (128 or 64) bits of the register. i don't know what the problem is.
 

hi
I had the same problem in ChipScope, not all signals appear in the list and I didn't find the answer.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top