Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Checking boundary DRCs in innovus

Status
Not open for further replies.

Qwerty112233

Member level 2
Member level 2
Joined
May 21, 2021
Messages
43
Helped
1
Reputation
2
Reaction score
3
Trophy points
8
Activity points
368
Hi,
i have a dummy design, where i have small blocks instantiated into a larger hierarchy. Now looking at their PG grid, was wondering if there;s a quick way to check abutment/alignment issues in innovus itself? Would like to avoid calibre or other tools right now due to the overhead for setting up the flows..

Thanks in advance!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top