We have a ICE cc2430 programmer available( with some basic debugging support ).
The hw design and software is open source but we also sell them **broken link removed**
hi everybody
we made the programmer for cc2431 using the circuit in the attached file. It is detecting and erasing the chip but the problem is while tryin to write the flash memory it takes long time in verifying the flash giving an eror message at last.....we have checked the circuit several times.....can somebody suggest a solution pls?
hi everybody
we made the programmer for cc2431 using the circuit in the attached file. It is detecting and erasing the chip but the problem is while tryin to write the flash memory it takes long time in verifying the flash giving an eror message at last.....we have checked the circuit several times.....can somebody suggest a solution pls?
Check your groud and cable length. Also take care that the power on cc2430 is properly decoupled.
Please note that the circuit above does not work connected to usb hubs.
I`m trying to use the same programmer. However I have a problem at the beggining, because it doesn`t detect the microcontroller in CC2431. I think that the programmer works correctly, it gives two rising edge transitions while reset is held low. But the 8051 doesn`t response. It is impossible to even get its ID.