chipburner
Newbie level 1
pic18f458 can bus
I tried to configure the CAN-BUS-unit on the PIC8f458.
If I want to send a message to the BUS, only the Transmission-status goes to busi, but never returns to ready.
Do I have to do other stuff than put the message into the send buffer?
(something like flush it or set a sendflag)
I'm using the c-libraries from the Microchip-Website
www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1824&appnote=en011822
I tried to configure the CAN-BUS-unit on the PIC8f458.
If I want to send a message to the BUS, only the Transmission-status goes to busi, but never returns to ready.
Do I have to do other stuff than put the message into the send buffer?
(something like flush it or set a sendflag)
I'm using the c-libraries from the Microchip-Website
www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1824&appnote=en011822