Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
plz tell me the exact number of I/O you want to use and i think you sketch it on paper and done it using PLC ...........no simulator u will need for it
using PLC is very expensive for such simple circuit if only 2 - 5 level. I suggest you to use Contactor and limit switch.. more easier to maintenance. and spare part replacement. Go for free sample of simulation for education purpose. https://www.metacafe.com/watch/1273284//
But when it goes too many level and complicated design of circuit... you have to pay for the effort.. every body have their own commitment to pay bill and get proper living accomodation.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
