shakeel_qureshi
Newbie level 3
Calibre LVS error: exit code 4 in pad layout:
--------------------------------------------------
I have a sheet of metal connected with a pin in layout and a pin in schematic. When I run Calibre LVS, I get error "exit code 4" and it says that the layout and schematic are empty.
Any ideas to solve this?
PS: calibre outputs attached!
--------------------------------------------------
I have a sheet of metal connected with a pin in layout and a pin in schematic. When I run Calibre LVS, I get error "exit code 4" and it says that the layout and schematic are empty.
Any ideas to solve this?
PS: calibre outputs attached!