Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
l'm using IC614 environment with a
TSMC65N PDK, and the body type
(integrated/detached) isn't shown when
making the schematic, why is that? do I
have to install the PDK again or is there
some sort of configuration I have to make
so I could show it?
Body type may be implicit to a library device, look to the device /
modeling manual for anything about that. There should be "stuff"
that describes a specific device's construction fully, although it may
be scattered across documents and suffer in translation.
Point is, maybe you specify the bulk type by specifying the transistor.
After all, swapping body doping has a wee effect on just about
everything, which one model would have to be extra elaborate to
cover (and why should it?).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
