Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

BUILD YOUR OWN BASIC STAMP

Status
Not open for further replies.

Fragrance

Advanced Member level 4
Joined
Jul 26, 2002
Messages
1,191
Helped
247
Reputation
494
Reaction score
198
Trophy points
1,343
Location
East Of Earth
Activity points
8,916
This is guide how to build your own basic satmp module all these information only for education purpose not for commercial use
see also MCU FORUM AND MY DIRECTORY KHALID AND ALSO DOWNLOAD
PICARO ACOMPLETE BASIC STAMP FIRMWARE AND see also this web
page
http://www.hippy.freeserve.co.uk/diystamp.htm#TheInterpreter

regards
khalid bhatti
 

@t

Member level 3
Joined
May 14, 2005
Messages
66
Helped
5
Reputation
10
Reaction score
4
Trophy points
1,288
Activity points
1,724
The article about the DIYstamp is very interesting.
It is only a pity that it only runs in a PC environment, as compiler. The executing part, the interpreter for the microchip, is (until now) not existing.
So this is more a Virtual Stamp (in the PC) than a DIY Stamp.
At.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top