Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Buckboost feedback loop injection resistor position?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,
Do you believe that R7 is a good place for a feedback loop injection resistor, for measuring the feedback loop with a gain/phase analyser?

I believe that loop can be broken anywhere(?), as long as for voltage injection, the impedance looking to the "input" side of the injection resistor, is far lower impedance than the impedance seen looking to the "output" side of the injection resistor?
 

Attachments

  • Buckboost _all ON.pdf
    27.7 KB · Views: 116

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top