Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Brownout detection for ATSAM3N00B microcontroller

Thread starter treez
Start date Mar 12, 2013

Status: Not open for further replies.

Mar 12, 2013

treez

Guest

Hello,

If i acivate "brownout protection" in the ATSAM3N00B microcontroller, then what does this do?

Does it mean the micro resets itself whenever its Vcc goes below 3V?

ATSAM3N00B datasheet
http://www.atmel.com/Images/doc11011.pdf

Status: Not open for further replies.

Similar threads

G
Recommend me microcontroller for this project
- Started by Gaber Mohamed Boraey
- Dec 4, 2024
- Replies: 20
Microcontrollers
S
Microcontroller input protection
- Started by Saeedk9574
- Oct 19, 2024
- Replies: 10
Microcontrollers
Anyone familiar with mature TI microcontroller TSS400
- Started by KlausST
- Yesterday at 6:36 PM
- Replies: 2
Microcontrollers
K
STM32. What should be done in firmware for VBUS detection through a GPIO pin?
- Started by kender
- Jun 12, 2024
- Replies: 1
Microcontrollers
Y
recomendation for microcontroller programmed DC-DC suited for power amplifier sequencer
- Started by yefj
- Apr 10, 2024
- Replies: 28
Microcontrollers

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Back

Top

Welcome to EDAboard.com

Brownout detection for ATSAM3N00B microcontroller

treez

Guest

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Connect with us

Online statistics

Forum statistics