mitch81
Member level 1
hi,
I am working on a microstrip-fed antenna with CST software. I can not find the boundary conditions because the ground plane does not cover the entire substrate face! What are the settings I choose from the following figure?
for example if ground plane cover all underside of the substrate, i use Zmin (Et=0) and Zmax(open space). but in this case, what can i do?
please help me!
I am working on a microstrip-fed antenna with CST software. I can not find the boundary conditions because the ground plane does not cover the entire substrate face! What are the settings I choose from the following figure?
for example if ground plane cover all underside of the substrate, i use Zmin (Et=0) and Zmax(open space). but in this case, what can i do?
please help me!