Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Boost Converter Problem

Status
Not open for further replies.

mengghee

Full Member level 3
Joined
Nov 29, 2005
Messages
164
Helped
8
Reputation
16
Reaction score
5
Trophy points
1,298
Location
United Kingdom
Activity points
3,112
I have attached a schematic diagram of my circuit and also a graph plotted on Duty Cycle Vs Vout. In the graph, it shows that when my duty cycle increases to 0.9, the output voltage is lower than the output voltage when the duty ratio is 0.8. how can that be possible ? so i thought i might have used the wrong component in pspice. but i can't find it. can anybody tell me what is wrong please. and does anybody know if i can plot a graph of Duty Cycle Vs Vout in Pspice ? thank you very much
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top