Bluetooth Module AUBTM 20

nirmala h · Aug 8, 2012

shree4u said:
Thanks nirmala for replying

i done USing enter after typing AT,AT+MODE, but it shows error. i set default baud rate 9600, zero parity, hardware control:none, ..etc, but i don't know where was the Problem....i used serial communication cable between aubtm-20 and comport of PC, how i need to enable command mode using aubtm-20..

Hello shree4u,

how about the properties have you enabled the required lines & try again..

shree4u · Aug 9, 2012

I enabled everything...but no responds from the bluetooth module...why this AT commands are not supporting to communicate? it will gives OK after powered up device.....afterwords won't give any reply if i type any AT commands it will give error?

any reply will appreciate

Thanx in advance

tahertinu · Aug 21, 2012

HI
I AM ABLE TO COMMUNICATE WITH MY PC AND ATmega8. and i ma also able to communicate with bluetooth and PC its all working good. but when i connect AUBTM-20 to ATmega8 it respond with "OK". But it is not receiving "LLL" command (any command) from Controller. im stuck here please anybody help me...please as soon as possible

Bluetooth Module AUBTM 20

nirmala h

Member level 1

shree4u

Junior Member level 3

tahertinu

Member level 4

Similar threads

Bluetooth Module AUBTM 20

nirmala h

Member level 1

shree4u

Junior Member level 3

tahertinu

Member level 4

Similar threads

Privacy & Transparency

Privacy & Transparency