metiz
Junior Member level 1
My welder broke a couple of days ago. It's a Bimax 132. The wirefeeder is dead. I still measure 20.8 volts inside the MIG torch and the switch on the torch is fine too but there's no voltage reaching the wirefeeder motor. The main power leads inside the welder still read 20 volts so that's okay, but because the wirefeeder doesn't work, there's no current to the MIG torch. I made a couple of pictures for clarification. Can anyone help me diagnose the problem?
This is the front of the welder
Rear
Better look of the pcb at the front of the welder
This is the front of the welder
Rear
Better look of the pcb at the front of the welder