Powerglide
Member level 1
I'm building a push pull dc to dc converter and when I measure the voltage on secondary of the ferrite transformer it gives me 25.5 AC output which is correct for the amount of turns on the secondary.
When I measure after the full wave rectifier , which consist of 2 mbr4045pt shotkky diodes I get a voltage reading of 16volts dc on a 160 watt load.
Is it possible to get such a high voltage drop with the shottky diodes and what other diodes can I use to improve this?
Also, is it possible to use a mosfet as a shottky diode in reverse bias with its internal diode?
When I measure after the full wave rectifier , which consist of 2 mbr4045pt shotkky diodes I get a voltage reading of 16volts dc on a 160 watt load.
Is it possible to get such a high voltage drop with the shottky diodes and what other diodes can I use to improve this?
Also, is it possible to use a mosfet as a shottky diode in reverse bias with its internal diode?