Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Endcap is placed at right or left most boundary filler cell for isolation of routing .
Route is not beyond endcap area.it does not allowed to routing come out side beyond endcap. i think the name itself its defintion.
Add endcap.tcl modified script enable to add a double coloum of tie fillercell (dummy poly gate for isolation) & endcap fller cell at the boundaries of each blockage areas define in the top including boundaries of the top itself.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.