Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Basic Question, turn on a diode

Status
Not open for further replies.
Y

yeahbuddy

Newbie level 1
Joined
May 25, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
I tried to design a circuit that turns on a diode when the output of a low effect board has a voltage of +2.5V and only the possibility to deliver 10micro amps

My solution is built on voltage division but the diode does not turn on.
Can anyone please send their schematic for solving this problem?

Best regars
Mike
 

you need tp turn on for 2.5v >=
or 2.8v=<
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top