Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

B and H recover post-processor FEMM4.2

Status
Not open for further replies.

said76

Newbie level 4
Newbie level 4
Joined
May 27, 2012
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,316
greetings;
I have a question,
To retrieve the values ​​B and A on the entire surface of the magnet (sum of all points)
I selected the post-processor FEMM4.2 the green icon.

And then I clicked on the full icon.

But the problem it gives B (Integral of B block over)
x-component: 1.34299e-006-meter ^ 3 Tesla (ie Bx =)
y-component: 1.30541e-006 Tesla meter ^ 3 (By then =)
Is that B = √ (Bx) 2 + (By) 2. If yes? Why t/m3 (volume) normally T, so I have to calculate the volume? if so, how?

H and no data in the integral control

Is there a command that calculates H?

Thank you. Cordially. Said76.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top