Your S-parameter file needs to be Touchstone file format compatible to use in any CAD tool including AWR MWO...
Looks this file is for two port is it correct ?
If So, it should have only 8 entries for each frequency say for S11magnitude & angle , S21 magnitude & angle, S12 magnitude & angle and S22 magnitude & angle only....Finally you should save this two port data as *.s2p file in order to import....
In your file it contains 11 entries & hence the problem...
Also I noticed the reference termination resistance as 0.5 ohm in the header definition is that correct? usually it is referred to 50 ohm termination...
Go through the "Touchstone® File Format Specification" document for more details on S-parameter data files...
vhdl.org/ibis/connector/touchstone_spec11.pdf
I solved the above error and also that pdf file was helpful , now that I converted it to Y paramteres ,I want to find the capacitance and resistance(i.e.Cgs,Cds,Rs,Rg,Rd).
How can I do that ? any formula to find it ?
you can define model, then opt the model params to match the S-params to the requirements.
Or you can get model params in ADS, extract from the s-params.
Im unable to understand ..how to define model ?..I want to find the above parameters for FET ATF-35143 ...In the data sheet they have given S parameters so I converted to Y parameters to find the above parameters...please guide me on this ...Thank you
I may be less intelligent than you , but I have done my homework .I already have this data sheet which I stated in my posts however it doesnt have the data which Im looking
for i.e. Parasitic capacitance and resistance (Cgs,Cds,Rs,Rg,Rd) .
I may be less intelligent than you , but I have done my homework .I already have this data sheet which I stated in my posts however it doesnt have the data which Im looking
for i.e. Parasitic capacitance and resistance (Cgs,Cds,Rs,Rg,Rd) .
He didn't give the datasheet to you, he basically gave you a project file that can be opened in ADS environment.
By using this project file, you can obtain your parasitic elements in "model" schematic..
So, be cool.. enjoy RF Engineering..
I solved the above error and also that pdf file was helpful , now that I converted it to Y paramteres ,I want to find the capacitance and resistance(i.e.Cgs,Cds,Rs,Rg,Rd).
How can I do that ? any formula to find it ?
In order to get these parameters just create a new schematic with the STATZ model (from nonlinear -> FETl)and approximately enter all the initial values then try to optimize parameters of the STATZ model to fit to the s-parameter...See STATZ model help & application for more details...
I didnt know what ADS is as Im using AWR MO though I have downloaded one now.
Thank you for the reply , there was a bit misunderstanding which is sorted now
---------- Post added at 14:57 ---------- Previous post was at 14:55 ----------
I didnt know what ADS is as Im using AWR MO though I have downloaded one now.
Thank you for the reply , there was a bit misunderstanding which is sorted now
---------- Post added at 15:18 ---------- Previous post was at 14:57 ----------
have installed ADS waiting for the license key , will follow the steps shown and hopefully shall get the results
Thank you
Ankit
I do not think ADS will solve your problem. It looks like you have the ADS project from Avago that has the model in it and it is likely that you will not be able to extract cds, cgs parameters from it. If you ask Avago, they will give you the equivalent project in MWO too. Can i ask what is the eventual goal here? Why do you want to extract these parameters?