jaydag71
Newbie level 6
Good morn and thanx for the response-- no I do not think that it is this reset IC I looked at it already and just can say plainly no.
I've attached a basic schematic of the part in its circuit- just one of the drivers but there are 2, basically the same but the other takes additional signals...
I hope that this will help put this one to bed once and for all- I have not had alot of time recently to pick this apart much more than I have but am still at a dead end so far as IDing the part! I am pretty darn sure we are talking fet here rather than transisotr but hjonestly I do not know enough to say for suire,, maybe this could be implemented using a transistor as well?
Either way I am about at the point where I am going to just order some generic fets and try them out- probably do some adjusting on the resistor vaules but other than that I think it would work.
Thanks for taking the time to look at this problem-- cheers j
I've attached a basic schematic of the part in its circuit- just one of the drivers but there are 2, basically the same but the other takes additional signals...
I hope that this will help put this one to bed once and for all- I have not had alot of time recently to pick this apart much more than I have but am still at a dead end so far as IDing the part! I am pretty darn sure we are talking fet here rather than transisotr but hjonestly I do not know enough to say for suire,, maybe this could be implemented using a transistor as well?
Either way I am about at the point where I am going to just order some generic fets and try them out- probably do some adjusting on the resistor vaules but other than that I think it would work.
Thanks for taking the time to look at this problem-- cheers j