Feb 9, 2016 #1 A Aks_srf Newbie level 3 Joined May 1, 2014 Messages 3 Helped 1 Reputation 2 Reaction score 1 Trophy points 3 Activity points 36 Hi, I am using ATM90E26 on a custom board and able to communicate with it using Uart with baud 9600. For the calibration purpose, i am following atmel application note mention here: http://www.atmel.com/Images/Atmel-46102-SE-M90E26-ApplicationNote.pdf After calibration, I am getting frequency of 51Hz and phase angle 350 only. All the energy registers are having zero values. I am using shunt and N Line metering method. Can anyone please suggest me the calibration procedure for the same?
Hi, I am using ATM90E26 on a custom board and able to communicate with it using Uart with baud 9600. For the calibration purpose, i am following atmel application note mention here: http://www.atmel.com/Images/Atmel-46102-SE-M90E26-ApplicationNote.pdf After calibration, I am getting frequency of 51Hz and phase angle 350 only. All the energy registers are having zero values. I am using shunt and N Line metering method. Can anyone please suggest me the calibration procedure for the same?