wlcsp
Full Member level 3
Mesh in HFSS
Hi all,
I am using HFSS 11.1. In HFSS, it is possible to select a particular object and assign mesh operation, for example to limit number of mesh.
Before we actually run the simulation, it is also possible to do "apply mesh operation" to see the initial mesh. However, this initial mesh generation does not depend on the mesh operation assignment set earlier. I tried to change the maximum number of mesh, however, it did not change the initial mesh.
Can anyone please confirm this?
regards,
wlcsp
Hi all,
I am using HFSS 11.1. In HFSS, it is possible to select a particular object and assign mesh operation, for example to limit number of mesh.
Before we actually run the simulation, it is also possible to do "apply mesh operation" to see the initial mesh. However, this initial mesh generation does not depend on the mesh operation assignment set earlier. I tried to change the maximum number of mesh, however, it did not change the initial mesh.
Can anyone please confirm this?
regards,
wlcsp