Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Arduino Uno for frequency measurement

Status
Not open for further replies.

nanana_1011

Member level 2
Member level 2
Joined
Nov 9, 2014
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,636
The Uno works properly. It can measure "integer" Hertz.
Is there any way to make it measure up to 0.01 Hz?
**broken link removed**
 

Didn't really look at the library's source code but based on what it says about the gate time, you cant get 0.01 Hz resolution using this library. But with the arduino uno, I think it should be possible (one way or another). It probably depends on what the max freq input you will be feeding your counter. You could probably get a 0.01 Hz resolution but for a smaller frequency range than the library's.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top