Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Anybody can assist me in making Double Sided PCB?

Status
Not open for further replies.

sundram_james

Newbie level 1
Joined
Dec 29, 2005
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
I am making Single Sided Board now. I have intention of making Double Sided board in my factory. I need support and guide in makind Double Sided board.
Please advise me the proper process flow of making it.

And also I have difficulty in getting Chemicals to make Double Sided board in my country MALAYSIA.

Anybody have any contact for me to get the chemical in my country or anybody can supply the chemicals for me?
 

hermin

Full Member level 2
Joined
Apr 19, 2005
Messages
132
Helped
12
Reputation
24
Reaction score
3
Trophy points
1,298
Activity points
2,481
is it possible to just smplify your design to make it at a single side? I tried doing a double sided using a Photo etched pcb, but it has issues with the top and bottom layer.
 

g86

Full Member level 4
Joined
Jan 21, 2003
Messages
212
Helped
11
Reputation
22
Reaction score
7
Trophy points
1,298
Location
On top of antenna :))
Activity points
2,232
sundram_james said:
I am making Single Sided Board now. I have intention of making Double Sided board in my factory. I need support and guide in makind Double Sided board.
Please advise me the proper process flow of making it.

And also I have difficulty in getting Chemicals to make Double Sided board in my country MALAYSIA.

Anybody have any contact for me to get the chemical in my country or anybody can supply the chemicals for me?
just use synthetic paints to protect one side while fabrication of another side. On completion of one side, remove that paint by alcoholic liquid. Now apply the paint on the completed side and etch undone side----->Only for chemical etching with feric chloride

:!::?::idea:
 

dozer

Newbie level 5
Joined
Jan 3, 2006
Messages
9
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
1,459
look for the Printed Circuit Handbook by Coombs.

I think it's "Clyde" Coombs.

It will tell you several different process-flows, including basic chemical makeup of baths.
 

Rame

Full Member level 6
Joined
Dec 23, 2005
Messages
373
Helped
47
Reputation
94
Reaction score
7
Trophy points
1,298
Location
BANGALORE
Activity points
3,813
Hi,

Buy a book called "Pcb design made simple" By Walter c Bossart,it will cover all the things your looking for....

Best Regards

Ramesh
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top