Hey folks,
I am simulating a simple 50 ohms transmission line in HFSS, however, the results are nowhere near expected results. I was expecting mag(z(1,1) to be roughly around 50 ohms or in between (40-70) but surprisingly I am getting worse than that. When simulate the same design in ADS it works perfectly. Any reason why? I would appreciate any input
The most common reason for unexpected results in EM are modelling mistakes by the user.
Examples: materials not properly assigned, mesh not appropriate, ports not appropriate ... this type of mistakes.
The most common reason for unexpected results in EM are modelling mistakes by the user.
Examples: materials not properly assigned, mesh not appropriate, ports not appropriate ... this type of mistakes.