xmalbadi
Newbie level 1
Hi,
I have an issue which was already asked several years ago with no solution, and I hope that during these years a solution has been provided!:grin:
The thing is that I have a MultiChannel design, where each of the four channels contains 6 opamps. I want to use quadruple opamp chips (multipart components, with parts A B C and D) so that the first channel would use one and a half chips and the second channel would use the remaining half and another full chip. The problem is that Altium does not use the remaining half chip on the second channel:-? So instead of getting 6 quadruple chips I get 8, four of which are not completely used.
Does anyone know if there is a solution to this?
I know I could put the opamps outside the channel but the schematic would get nasty...
I have an issue which was already asked several years ago with no solution, and I hope that during these years a solution has been provided!:grin:
The thing is that I have a MultiChannel design, where each of the four channels contains 6 opamps. I want to use quadruple opamp chips (multipart components, with parts A B C and D) so that the first channel would use one and a half chips and the second channel would use the remaining half and another full chip. The problem is that Altium does not use the remaining half chip on the second channel:-? So instead of getting 6 quadruple chips I get 8, four of which are not completely used.
Does anyone know if there is a solution to this?
I know I could put the opamps outside the channel but the schematic would get nasty...