Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Altium, Routing traces with different sizes

Status
Not open for further replies.
N

Nermeen

Newbie level 4
Newbie level 4
Joined
Feb 28, 2013
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,322
Hi there, i want to route 8 layer pcb design in Altium .. and i chose AutoRouting .. but there is a problem that tracks of my design will be routed with different sizes .. i don't know how to do this with AutoRouting .. Can Any One Help me in this ? ... #Thanks.
 
Last edited:

You would have to set a rule up for each net in the rule editor under width rule, So you would set this up for each net

sorry it's a quick reply but got to dash off
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top