jgabcgr
Newbie level 4
Hello, I've been designing a pcb with an RF chip.
There's a few polygon pours around the board and I want to place another one, a whole Ground, over the whole board to fill the rest gaps.
I set the polygon's order to lowest, because it's over the rest polygons and everything looks good. Gaps are now filled with the "ground polygon"
The problem is when I export the gerber some areas are not showed filled as though I see them in design or Altium's 3D viewer.
I'm going to upload some photos.
Thanks in advance!
There's a few polygon pours around the board and I want to place another one, a whole Ground, over the whole board to fill the rest gaps.
I set the polygon's order to lowest, because it's over the rest polygons and everything looks good. Gaps are now filled with the "ground polygon"
The problem is when I export the gerber some areas are not showed filled as though I see them in design or Altium's 3D viewer.
I'm going to upload some photos.
Thanks in advance!